Shure AXT600US Spectrum Manager

Features of the Shure AXT600US Spectrum Manager:

• Scans UHF Spectrum (470 to 952 MHz)
• Backup Frequency Monitoring in Real Time
• Backup Frequency Display
• Use with Axient Channels
• RF Signal Cascade for up to 5 Receivers

Specifications:

RF Tuning Frequency Range 470 to 865, 925 to 952 MHz
RF Tuning Step Size 25, 200, and 1000 kHz
Scan Time The Spectrum Manager scans the entire RF tuning frequency range in 64 seconds using 8 scanning modules in parallel.
Scan time per 60 MHz may be less for specified ranges that allow scanning modules to work in parallel.

Step Size:
25 kHz: Max scan time per 60 MHz = 48 seconds
200 kHz*: Max scan time per 60 MHz = 7 seconds
1000 kHz*: Max scan time per 60 MHz = 1 second

*Available only with WWB6 control
Noise Floor Resolution Bandwidth
25 kHz: -110 dBm
200 kHz: -100 dBm
1000 kHz: -90 dBm
Image Rejection > 110 dB, typical
Spurious Response < -100 dBm, typical Ultimate Quieting > 90 dB, A-weighted
Housing Steel; extruded aluminum
Power Requirements 100 to 240 VAC, 50-60 Hz
Current Drain 0.8 A RMS (referenced at 120 VAC)
Operating Temperature Range 0 to 145°F / -18 to 63°C
RF Input Specs
Connector Type BNC
Configuration Unbalanced, active
Maximum Input Level -20 dBm
Impedance 50 Ohms
Bias Voltage 12 VDC, 150 mA (300 mA maximum)
Cascade Output
Connector Type BNC
Configuration Unbalanced, active
Impedance 50 Ohms
Insertion Loss < 5 dB
Monitor Output
Audio Frequency Response 40 Hz to 18 kHz, ±3 dB
Configuration 1/4″ / 6.3 mm, unbalanced mono (will drive stereo headphones)
Impedance 50 Ohms
Maximum Signal Level 1 W @ 63 Ohms (45 kHz max deviation)
Pin Assignments Tip: Audio +
Ring: Audio +
Sleeve: Ground
Networking
PoE 50 VDC, Class 1
Network Interface Dual port Ethernet 10/100
Network Addressing Capability DHCP or manual IP address
Physical Size
Dimensions 19 x 1.7 x 14.4″ / 483 x 44 x 366 cm
Weight 12.1 lb / 5.5 kg